From: Michael <9606729f@student.gla.ac.uk>
To: ml@qoole.com
Reply-To: ml@qoole.com
Date: Thu, 12 Feb 1998 10:59:29 +0000
Subject: Re: entities not appearing

I found that this was happening to me because I was positioning the 
entities too low. The ideal height (for the centre of the entity) is 
about chest height for the player entity.
Basically position them real high above the ground and re-compile. if 
you get messages at the start like 
"shotgun drop (12, 435, 198)" (not sure of syntax but something like 
that)
Then you'll find that they should appear. Now just lower them slowly 
and try again until you find a height where they appear without the 
falling message.

Mic

> Hey all,
> Only about half of my entities are showing up on my map. One thing that is
> not working are weapons.  They are not there after I compile and run my
> map.  There are no special flags set on them or anything, and it is just one
> simple square room.   There are a few other entities that are not showing up
> too.  Am I overlooking something obvious??
> Matt Shumway
> 
> 
That's all folks

Mic

e-mail:  9606729f@ug.student.gla